Which wire on a TP sensor should be back probed to check for a voltage signal to the PCM?
A) Ground wire
B) Meter should be connected between 5-volt reference and ground
C) 5-volt reference (Vref)
D) Signal wire
Answer: D) Signal wire
You might also like to view...
The least material condition of the shaft dimension Ø.625/.620 is:
a. .625 b. .620
Persons who are naturally monotonic are perfect for answering a business telephone
Indicate whether the statement is true or false
The subsequent problems deal with the circuit below:
Note: Each question is independent and doesn't depend on results from previous questions. The only values known initially are the values provided in each question.If B=0 while D changes state from 0 to 1, X will
A. be uncertain B. become (or remain) 1 C. remain unchanged (regardless of whether the initial value is 0 or 1) D. become (or remain) 0
Determine the maximum power that can be delivered to the variable resistor R in the circuit of Fig. 4.139.
 FIGURE 1.png)