After a TP sensor has been tested using the MIN/MAX function on a DMM, a reading of zero volts is displayed. Which of these does this reading indicate?
A) The TP sensor is shorted
B) The TP sensor signal is shorted to 5-volt reference
C) The TP sensor is open at one point during the test
D) Both B and C are possible
C
You might also like to view...
When making a decorator's bow, _____
A) cut all the ribbon in 4- to 6-inch pieces B) cut one piece 6 inches long for the center of the bow C) cut one piece 6 inches long for the tails of the bow D) none of the above
Which of the following is not listed as an element that goes into a scenario (i.e. from Figure 8.6)?
A. Key issues and questions B. Driving forces C. Logics D. Learning
What is considered the “evaporator temperature”?
a. The temperature of the refrigerant inside the evaporator tubing. b. The temperature of the air entering the evaporator. c. The temperature of the air leaving the evaporator. d. The temperature of the suction line leaving the evaporator.
Used in an integral power steering gear, the rotary valve contains all of these EXCEPT ________
A) A pinion drive gear B) An inner valve element C) A torsion bar D) An outer valve element