The term MOST-Likely used to describe the inboard CV joint is:
A. spider gear
B. hunting gearset
C. pumpkin
D. plunge joint
Answer: D
You might also like to view...
In your own words, summarize the OSHA General Duty Clause.
List and discuss in detail at least three of the primary rights of employees under OSHA and the OSH Act of 1970.
Fill in the blank(s) with the appropriate word(s).
An AC induction machine has six poles and is designed for 60-Hz, 240-V (rms) operation. When the machine operates with 10 percent slip, it produces 60 N-m of torque.
a. The machine is now used in conjunction with a friction load that opposes a torque of 50 N-m. Determine the speed and slip of the machine when used with the above-mentioned load. b. If the machine has an efficiency of 92 percent, what minimum rms current is required for operation with the load of part a? (Hint: You may assume that the speed–torque curve is approximately linear in the region of interest.)
A good guide for parging is a piece of flat wood board laid on top of the last course and allowed to project _____.
A. over the back of the wall about 1/4" B. over the back of the wall about 3/8" C. over the front of the wall about 1/2" D. over the front of the wall about 5/8"