What should be used to remove a press-fit bearing from a shaft to minimize damage to both the shaft and the gear?
A. hammer and drift
B. pneumatic hammer
C. bearing puller
D. bearing mandrel
Answer: C
You might also like to view...
When a fastener is torqued to specification, approximately how much of the twisting force is required to overcome thread friction?
A. 10% B. 25% C. 50% D. 90%
Where would you most likely find a thermocouple pyrometer on a current highway diesel engine?
A. 12-inches downstream from the turbo B. diesel particulate filter (DPF) C. exhaust gas recirculation (EGR) heat exchanger D. selective catalytic reduction (SCR) circuit.
Answer the following statement(s) true (T) or false (F)
1. For a radio station to transmit an intended signal, their operating frequency must be tuned to a specific carrier frequency. 2. Digital signals have only two possible output variations. 3. AM antennas are physically smaller than that of FM antennas. 4. Wireless transmissions are more secure than hard-wired transmissions. 5. A typical C-band satellite will include twenty-four transponders, all on separate channel frequencies.
Usually the air bag system stores two types of fault codes: active and ____.
A. stored B. inactive C. intermittent D. critical