Which of the following is true of thin-gauge welding?
A. It is rarely done with fillet welds.
B. It usually uses a butt-type joint.
C. It is rarely used to join a thin member to a thicker member.
D. It is the type of weld used to put panels in frames.
Answer: D
You might also like to view...
The HVAC control module uses ________ to control high current loads in the A/C system.
A) Switches B) Vacuum hoses C) Relays D) LEDs
After being energized, what type of function could a typical relay with normally closed contacts directly
perform? a. De-energize a crankcase heater b. Energize an inducer motor c. Start a compressor d. Complete a circuit to a motor start winding
Why is supplemental heat the second stage of heating and not the first?
A) Because the thermostat won't let it energize right away B) Because auxiliary heat is inexpensive C) Because electric strip heaters turn on and off constantly D) Because electric strip heaters produce heat less efficiently
If viewing planes were placed on all four sides on an object and on top of the object the object would be encased in a
A. transparent box B. square box C. solid box