A fuel pump was measured for current draw and amperage exceeded factory specifications. This can be caused by a ________
A) Defective fuel pump B) Clogged fuel filter
C) Restricted fuel line D) Any of the above
D
You might also like to view...
This is the current document that recommends dimensioning and tolerancing standards for use on engineering prints.
a. ASME Y14.1 b. ASME Y14.2 c. ASME Y14.5 d. ASME Y14.6
Computer investigation of wind load on a building frame.
Case 1: The columns and girders of the rigid building frame in Figure P5.58 have been
designed initially for vertical load as specified by the building code. Floor beams are
connected to columns by rigid joints. As part of the design, the building frame must be
checked for lateral deflection under the 0.8 kip/ft wind load to ensure that lateral displacement
will not damage the exterior walls attached to the structural frame. If the code requires that
the maximum lateral deflection at the top of the roof not exceed 0.48 in. to prevent damage to
the exterior walls, is the building frame sufficiently stiff to satisfy this requirement?
Case 2: If the bases of the columns at point A and F are attached to the foundations by fixed
supports instead of pin supports, how much is the lateral deflection at joint D reduced?
Case 3: If a pin-connected diagonal bar bracing with a 2 in. × 2 in. square cross section
running from support A to joint E is added, determine the lateral deflection at joint D. Assume
pin supports at joints A and F.
For the columns, I = 640 in. 4 and A = 17.9 in.2; for the girders, I = 800 in. 4 and A = 11.8 in. 2 ;
for the diagonal brace, A = 4 in. 2 . Use E = 29,000 ksi.
A vehicle being inspected under an OBD-II testing program and the MIL is ON. What will be the results of the inspection?
A) The vehicle will fail the test. B) The vehicle will receive an 80% pass rate. C) The vehicle will pass the test. D) None of these
An alternator is an electronic component that only conducts electricity when a certain voltage is reached.
Answer the following statement true (T) or false (F)