The follower rest jaws can be made to clear the dead center or tailstock spindle when the tool is returned to the start of the cut by:

A) Making the shaft two inches longer
B) Moving the jaws to the left of the tool
C) Readjusting the the jaws outward and back in each pass
D) Making the shaft longer and undercutting the end


D

Trades & Technology

You might also like to view...

Determine the equivalent resistance of the infinite network of resistors in the circuit of Figure P2.62.



What will be an ideal response?

Trades & Technology

What are the most common loads in HVACR systems?

A) Lights B) Motors C) Wires D) Resistance heaters

Trades & Technology

The major reason for brake pedal pulsation during braking is due to excessive rotor thickness variation

Indicate whether the statement is true or false

Trades & Technology

Which one of the following statements about the response curve of a system is NOT true?

A) The length of the settling time must be reduced. B) Reduce the dead time C) Maximize the minimum value of error D) Reduce the steady-state error

Trades & Technology