Electric charge is measured in ____.
a. coulombs
b. joules
c. pascals
d. ohms
a. coulombs
You might also like to view...
Conduit that passes from a classified location into an unclassified location requires the use of a(n) _____.
a. nylon fitting b. PVC fitting c. standard entrance elbow d. sealing fitting
The backlash is less than specifications (too low). This will cause the ring gear tooth pattern to be too close to the ________.
A) Face B) Flank C) Toe D) Heel
It is desired to transfer maximum power to the load Z in the circuit shown below. Find Z and the maximum average power. Let vs = 100 sin(100t) V.
A signal showing the voltage of a battery displayed on a digital storage oscilloscope (DSO) is being discussed. Technician A says that the display will show one horizontal line above the zero line. Technician B says that the display will show a line sloping upward from zero to the battery voltage level. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician