The dimensioning system most commonly used in architecture is known as:
A. alignment dimensioning
B. unidirectional dimensioning
C. aligned dimensioning
D. architectural dimensioning
E. none of the above
Answer: C
You might also like to view...
Describe two symptoms of a 16% oxygen level.
What will be an ideal response?
_____ is an integral part of horse management in keeping pastures from being over grazed.
Fill in the blank(s) with the appropriate word(s).
Which of the following statements regarding dimensioning is not true?
a. Dimensions should be given where the shapes (contours) are shown. b. Finish marks are shown in every view where the finished surface appears as an edge. c. Dimensioning in engineering drawing involves two steps: size dimensions and location dimensions. d. Current ANSI standards require that the diameter symbol (DIA) be used following the dimension. e. Notes should always be lettered horizontally.
Technician A says that when back-probing an electrical connector with a T-pin, it is permissible to poke the T-pin through the wire as long as you do it carefully. Technician B says that it is permissible to back-probe an electrical connector on a 42-volt system as well as on a 14-volt system. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B