Describe the method called cross-reference zoning used to indicate the location of a view back to the viewing location on a previous page.
What will be an ideal response?
Auxiliary views can be found on a sheet other than where the viewing plane lines appear. The auxiliary view is located on a different page and is labeled with the sheet number and zone of the cross-reference viewing plane. ASME Y14.3 does not recommend a specific zone and page identification system. The viewing plane and auxiliary views should have a note correlating each between sheets, such as: LOCATED ON SHEET 2 ZONE B4 next to the viewing plane on the sheet where the viewing plane is located, and SEE SHEET 1 ZONE A5 next to the view on the sheet where the view is located. Each sheet has the same drawing number or part number. The sheets also have page numbers.
You might also like to view...
Technician A says that instrument panel illumination may be controlled by a rheostat. Technician B says that instrument panel illumination may be controlled by pulse width modulation. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
What type of nozzle tip would you select when using abrasive materials (like fertilizers)? What nozzle tips last the longest? How would you go about checking a nozzle tip for wear?
What will be an ideal response?
The pressure of a refrigerant cylinder containing saturated refrigerant:
A) Is determined entirely by the amount of gas in the cylinder. B) Is determined entirely by the temperature of the refrigerant. C) Is determined by the amount of liquid in the cylinder. D) Is determined by both the amount of refrigerant in the cylinder and the cylinder temperature.
A bolt is described as M8 X 1.5. Technician A says that the bolt is 8 mm long. Technician B says that this is a UNF bolt. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician