When you work with large files, the SELECTLOAD and SELECTOPEN commands can be used to allow a specific portion of the drawing to be accessed.
Answer the following statement true (T) or false (F)
False
You might also like to view...
Referring to the figure shown below, assuming fuse F3 is supplied with ignition voltage, which failure(s) could cause the pump motor to run at all times even with ignition switch in the OFF position?
A. Defective flow switch B. Defective pressure differential switch C. Misadjusted hydraulic brake switch D. All of the above could cause this failure.
If joists are lapped over the girder, the minimum amount of lap is 4 inches and the maximum overhang is ____ inches.
a.4 b.6 c.8 d.12
Which of these is NOT a step in de-powering the high voltage system?
A) Remove the high voltage service plug B) Remove the ground interlock fuse C) Remove the ignition key D) Disconnect the 12 volt battery
The higher the AW G number, __________
A) The thicker the insulation B) The smaller the wire diameter C) The more strands in the conductor core D) The larger the wire diameter