When brazing larger joints, _____
A) a 95% tin/5% antimony solder is the best choice
B) use a soldering flux to make it easier to reach the needed temperature
C) small sections of the joint can be heated and brazed
D) use only a single orifice torch tip
C
You might also like to view...
Technician A says the sight glass is located in the suction line, between the accumulator and compressor. Technician B says the sight glass is located on the receiver/dryer. Who is correct?
A. A only B. B only C. Both A & B D. Neither A nor B
Power is the rate at which a twisting force is applied.
Answer the following statement true (T) or false (F)
Describe what is meant by the term "line-balancing."
What will be an ideal response?
Measurements for ____ and the building industry are usually given in feet and inches.
A. manufacturing industries B. structural work C. mass production D. research