A clothing manufacturing plant would most likely be classified as _____.
a. Class I, Division 1
b. Class I, Division 2
c. Class II, Division 1
d. Class III
d. Class III
You might also like to view...
When done correctly, _____ can provide communication researchers with valuable insights into how messages are communicated
a. analytical review b. content review c. content analysis d. survey review
What is the positional tolerance using different material condition symbols at the actual sizes shown in the table?
Given:
a. Positional tolerance Ø0.02 at true position in reference to datums L, M, N.
b. Hole size Ø8.50/8.40.
A TAB technician determines that the total airflow entering the return grilles is much lower than the amount of air the blower is moving. This indicates that:
A) There are leaks in the supply-side ductwork. B) There are leaks in the return-side ductwork. C) There is too much restriction in the return-side ductwork. D) There is too much restriction in the supply-side ductwork.
Which of the following explains why some types of air suspension height control valves have to be held in an off-horizontal position for up to 15 seconds before there is a response to the movement?
A. valve is defective B. cold weather operation C. hydraulic reaction delay D. pneumatic-actuated reaction delay