Most outboard CV joints are held onto the driveshaft by using a ________ at the end of the shaft
A) Snap ring B) Circlip C) Cap screw D) Any of these
A
Trades & Technology
You might also like to view...
The cabinet part marked A in the figure is a(n) _____.
a. scribe molding
b. end panel
c. face frame
d. shelf support
Trades & Technology
Plumbing detils, like mechanical details, are often not repeated from job to job.
Answer the following statement true (T) or false (F)
Trades & Technology
What is the fundamental principle and use of spread spectrum?
What will be an ideal response?
Trades & Technology
Employees should be vigilant in observing and reporting which of the following types of behavior?
A) Bizarre B) Abusive or aggressive C) Unusual D) All of the above
Trades & Technology