The first step in brake pad replacement is ________
A) Remove the pad retaining pins
B) Remove some fluid from the master cylinder reservoir
C) Raise the car
D) Swing the caliper away from the anchor plate
B
You might also like to view...
The term racking refers to the effect produced on the structure mainly by
A) lateral loads. B) dead loads. C) floor live loads. D) roof live load. E) none of the above.
In the right triangle below, when side x = side y, what is the value of the cotangent function?
Fill in the blank(s) with the appropriate word(s).
Where the ungrounded supply conductors are larger than 1100 kcmil copper or 1750 kcmil aluminum, the supply-side bonding jumper shall have an area not less than ____ of the area of the largest set of ungrounded supply conductors or equivalent area for parallel supply conductors.
A. 10 1/2% B. 12 1/2% C. 15 1/2% D. 18 1/2%
To determine the sizing requirements and nailing requirements for a built-up girder when renovating you should ________
A) Check the International Residential Code B) Check with the homeowner C) Check with the manufacturer D) Check with your building supply specialist