If the length of a crankshaft throw was changed either up or down, which of the following would be directly affected?

A. engine torque
B. engine rpm
C. engine noise
D. engine vibration


Answer: A

Trades & Technology

You might also like to view...

A building requires four drilled piers with a shaft diameter of 24 inches, a bell diameter of 48 inches, and a bell angle of 50 degrees. The height from the bottom of the bell to the top of the pier is 10 feet. Using a waste factor of 12 percent, determine the number of cubic yards of concrete needed to pour the drilled piers.

What will be an ideal response?

Trades & Technology

The first Intel 8-bit microprocessor was designated

A) 8085. B) 8008. C) 6800. D) 8080.

Trades & Technology

Which microprocessor bus is only used to output information?

A) data bus B) control bus C) address bus D) None serve only as output buses.

Trades & Technology

Refer to the figure. Solve for c-c of pipe K

Fill in the blank(s) with the appropriate word(s).

Trades & Technology