The instant the ignition switch is turned to the start position, ________
A) The hold in winding is energized
B) The pull in winding is energized
C) The starter motor starts to rotate before energizing the starter pinion gear
D) Both the pull in winding and the hold in winding are energized
D
You might also like to view...
Using the Pythagorean Theorem, calculate the length c of a 45-degree with a run and a rise of 3’4”(answer in inches and feet, roung to nearest tenth of an inch).
What will be an ideal response?
To enter single line text you must first enter all of these except :
a. alignment b. rotation angle c. start point d. text height
Two technicians are discussing loosening a stuck bleeder valve. Technician A says to use a 6-point wrench and simply pull on the wrench until it loosens. Technician B says that a shock is usually necessary to loosen a stuck bleeder valve. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
A voltage source is used to charge an automotive battery as shown in Figure P9.65(a). At t = t1, the protective circuitry of the source causes switch S1 to close, and the source voltage goes to zero. Find the currents IS , IB, and ISW for the following conditions:
a. t = t ? 1
b. t = t + 1
c. What will happen to the battery after the switch closes?
Now we are going to charge the battery, using the circuit of Figure P9.65(b). Repeat parts a and b if the diode has an offset voltage of 0.6 V. 