Weight transfer during braking is caused by ________.

In industry, what are the most common reasons for reverse engineering?

What will be an ideal response?

Which of the following types of fuel pump can be used as the high pressure pump in a typical CR systems?

A. Vane pump. B. Swash plate pump. C. Crescent pump. D. Inline piston pumps.

Which of the following is NOT good practice when adjusting for positive caster?

A. more positive caster should be set on the left side B. there should be no more than 1/2 degree difference from left to right C. the thickest part of the caster shim goes toward the rear D. caster readings must factor for any frame angle off level

The derivative control function is not necessary if the controlled variable does not lag behind the changing controller output signal.

Answer the following statement true (T) or false (F)