What cooling towers use temperature differences inside and outside the stack to facilitate air movement?

A) Induced draft tower
B) Forced draft tower
C) Closed circuit cooling tower
D) Natural draft tower


Answer: D
Explanation: A) Incorrect. Induced draft towers have fans at the top of the tower that pull air through the equipment components.
B) Incorrect. Forced draft towers have fans or blowers at the bottom of the tower that force air through the equipment.
C) Incorrect. Closed circuit cooling towers use a heat exchange coil through which the working fluid passes and over which water is sprayed.
D) Correct. Natural draft towers use temperature differences inside and outside the stack to facilitate air movement.

Trades & Technology

You might also like to view...

Brent's Auto Repair needs to replenish the shop supplies and must borrow $16,250 for three years at 7.5%.  How much is the monthly payment on this loan?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

A P0106 DTC is being discussed. Technician A says a damaged or missing MAP sensor O-ring could be the cause. Technician B says a defective MAP sensor could be the cause. Who is right?

A) Technician A only B) Technician B only C) Both technicians A and B D) Neither technician A nor B

Trades & Technology

Answer the following statement(s) true (T) or false (F)

1. The frames of motors are required to be connected to an equipment grounding conductor in accordance with 250.110. 2. Electric signs are required to be grounded in accordance with the rules in 600.7 rather than according to Article 250. 3. Listed floor boxes are required to have a device-to-box- bonding jumper. 4. Aluminum equipment grounding conductors are permitted for an underground feeder to an agricultural building so long as it is listed for direct burial applications.

Trades & Technology

If a vehicle is equipped with at winter front it:

A. Must not cover more that 70% of the radiator surface B. Must not cover more than 75% of the radiator surface C. Must not cover more than 80% of the radiator surface D. Must not cover more than 85% of the radiator surface

Trades & Technology