Technician A says that alignment sensor calibration is needed to compensate for bent wheels. Technician B says that sensor calibration is needed to compensate for uneven installation of the sensor on the wheel. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician


C

Trades & Technology

You might also like to view...

When using the metric system, the cross-section of a piece of lumber will be stated in ____ using the actual dimensions in preference to the nominal dimensions.

A. millimeters B. centimeters C. decimeters D. decameters

Trades & Technology

In an arrangement, the various sizes of flowers compared to each other is called ____________________

Fill in the blank(s) with correct word

Trades & Technology

What power source does a heater normally operate on?

A) 300 V to 400 V B) 208 V to 240 V C) 150 V to 250 V D) 200 V to 240 V

Trades & Technology

Using Excel, create a table that shows the relationship among the units of height of people in centimeters, inches, and feet in the range of 150 cm to 2 m. Use increments of 5 cm.

What will be an ideal response?

Trades & Technology