Most pipe-cutting dies are ground _____ to cut mild steel pipe.
?
 

A. deep?
B. horizontally?
C. vertically?
D. at an angle?


Answer: A

Trades & Technology

You might also like to view...

Most steam traps fail in the _____ position.

a. up b. down c. open d. closed

Trades & Technology

The number of drawings in a plan set for a commercial project may be _____.

a. 5 to 10 b. 10 to 20 c. 50 to 60 d. over 100

Trades & Technology

Select the possible causes of an underfeeding TEV. You may choose more than one

A) Undersized valve B) Restricted filter drier C) High superheat adjustment D) Oversized TEV E) Low superheat adjustment F) Restricted inlet screen on TEV G) TEV sensing bulb not making good thermal contact H) Dead thermostatic bulb charge

Trades & Technology

Two technicians are discussing bias ply tires. Technician A says bias ply tires contribute to a smooth ride. Technician B says that bias ply tires are used on larger trucks and trailers today. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology