Gear _____________________ refers to the number of teeth per given unit of pitch diameter.
A. ratio
B. diameter
C. pitch
D. tooth pattern
Answer: C
You might also like to view...
When starting up a hot-water boiler, treated water is used to fill the _____.
a. boiler, piping system, and terminals b. boiler to its normal water line c. boiler below its normal water line d. boiler to overflowing
What is the cause of thatch? How can thatch buildup be prevented and controlled?
What will be an ideal response?
The wet coil static pressure drop is:
A) Higher than the dry coil static pressure drop. B) Can only be determined when the coil is submerged in water. C) About the same as the dry coil static pressure drop. D) Lower than the dry coil static pressure drop.
In the above figure, if the load decreases and causes the motor speed to increase, the voltage at the wiper arm of R11 ____________________ (increases, decreases), which causes the output of op amp 2 to become more ____________________ (negative, positive), which makes the output of the summing amp become more ____________________ (negative, positive), and causes the motor speed to ____________________ (increase, slow down).
Fill in the blank(s) with the appropriate word(s).