In CADD, use the ____ command to adjust corners.
A. ISNAP
B. FILLET
C. OFFSET
D. PSNAP
Answer: B
Trades & Technology
You might also like to view...
In an aircraft, for what reason would an initiator be used?
What will be an ideal response?
Trades & Technology
When dealing with construction joints, care must be taken to ensure _____
a. they are not too close together b. a good bond between layers c. reinforcement is properly installed d. mating surfaces are smooth
Trades & Technology
If the value of the external resistor Rg increases, the gain of an instrumentation amplifier
A) decreases B) does not change C) increases D) both a and c
Trades & Technology
The compression ratio for an R-22 compressor operating with 68.5 psig suction pressure and 260 psig heat pressure is ____________________.
Fill in the blank(s) with the appropriate word(s).
Trades & Technology