Typical clearance should be about ________ between each friction surface-lined and unlined plate.
A) 0.010 to 0.015 inch (0.25 to 0.38 mm)
B) 0.050 to 0.075 inch (1.3 to 1.9 mm)
C) 0.020 to 0.035 inch (0.050 to 0.090 mm)
D) 0.001 to 0.005 inch (0.025 to 0.012 mm)
A) 0.010 to 0.015 inch (0.25 to 0.38 mm)
You might also like to view...
When testing capacitors, if the capacitor is good, the microammeter should indicate ____ current.
A. zero B. high C. low D. oscillating
To avoid an overly ____________________ system, make sure you establish relationships between instances with constraints rather than merely locate instances by moving them in 3-D space.
Fill in the blank(s) with the appropriate word(s).
You built a patio alongside an in-ground pool. It is a rectangular patio 10 feet by 14 feet. You used bricks 4 by 8 by 2 inches for the floor. You removed 8 inches of dirt and replaced it with 6 inches of sand.
a. What is the area of the patio in square inches? b. How many bricks were needed? c. How many cubic feet of dirt were removed? d. How many cubic feet of sand were needed?
_____ is a disease that attacks the stem of plants
A) Systemic B) Mold C) Rust D) Anthracnose