The distance from the end of the pipe to the center of the fitting is called the _____.
a. run
b. specifications
c. pitch
d. takeout
d. takeout
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. The ohmmeter indicates the amount of potential between two points. 2. Many service technicians use a jumper to short the thermostat contacts. 3. Technicians rarely use the hopscotch method of troubleshooting. 4. The resistance reading will generally give some indication as to the state of the winding 5. The ohmmeter is used to measure the actual amount of electricity flowing in a circuit.
Ricardo replaced some gears in his tractor. They had to be adjusted to 0.08 ± 0.001 of an inch clearance.What are the upper and lower limits?
What will be an ideal response?
Why do we need a starter on an internal combustion engine?
What will be an ideal response?
When a toggle switch is in the off position, the NO contacts are an open circuit and the NC contacts are shorted
Indicate whether the statement is true or false