PROBLEM 3.113 Three points on the nonlinear stress-strain diagram used in Prob. 3.112 are (0, 0), (0.0015, 55 MPa), and (0.003, 80 MPa). By fitting the polynomial through these points, the following approximate relation has been obtained. Solve Prob. 3.113 using this relation, Eq. (3.2), and Eq. (3.26). PROBLEM 3.112 A 50-mm diameter cylinder is made of a brass for which the stress-strain diagram is as shown. Knowing that the angle of twist is 5? in a 725-mm length, determine by approximate means the magnitude T of torque applied to the shaft.


Trades & Technology

You might also like to view...

A test taken in the ____ position would usually allow the welder to work in the flat, horizontal, and vertical positions, depending on the code requirements.

A. horizontal B. vertical C. longitudinal D. flat

Trades & Technology

What are the key devices of a closed-loop system?

What will be an ideal response?

Trades & Technology

Which new type of military weapon was banned under the 1899 Hague Convention on Land Warfare?

a. machine guns b. poison gas c. grenades d. flamethrowers

Trades & Technology

Nearly all gasoline purchased today for fuel is a blend with 10 percent _____

A) biomass B) methanol C) ethanol D) octane

Trades & Technology