Why are anchor rod holes through baseplates oversized?
What will be an ideal response?
Anchor rod holes are usually oversized to allow for slight errors in placing the bolts in the field and to provide the iron workers room for adjustments as required during field erection.
You might also like to view...
Research shows that 12 percent of the total in-place cost of the average project is due to the _____.
a. need to perform rework b. failure to secure loans c. lack of quality vendors d. improper unit measuring
Pump TS # 3
_____ is when one weld pass does not melt the surface of a previous weld pass.? ?
A. Incomplete fusion? B. Inadequate joint penetration? C. Improper joint fit-up? D. Inadequate agitation?
________ doped amplifiers have revolutionized the long haul network by eliminating the need to locate DWDM multiplexers every 60 miles, thus cutting costs enormously
Fill in the blank(s) with correct word