Why is it important to cycle the furnace on and off several times when replacing a sequencer?
A) It is important to make sure the heating elements and the blower are turning on at the same time.
B) It is important to make sure that only the heating elements are coming on and not the blower.
C) It is important to make sure the power is working correctly.
D) It is important to make sure the heating elements and the blower are switching on and off in the correct cycle.
D
You might also like to view...
The in-place kiln and replacement kiln (GH) were evaluated using a fixed study peĀriod of 6 years. This is a significantly shortened period compared to the expected 12-year life of the challenger. Use the best estimates available throughout this case to determine the impact on the capital recovery amount for the replacement kiln (GH) of shortening the evaluation time from 12 to 6 years.
What will be an ideal response?
The DOE?s goal for wind-generated power is for it to produce 20 percent of our electrical power by _____
a. 2016 b. 2030 c. 2035 d. 2050
The voltage vL (t) across a 10-mH inductor is shown in Figure P4.20. Find the current iL (t) through the inductor. Assume iL (0) = 0A.
The circuit of Figure P12.4 is a very effective battery charger. Its operation is simple, and the TIP-33C npn power transistor can sink 10 A if a big enough heat sink is used. Assuming that the transistor remains in the active operating region, determine the power delivered to the 1.2-V rechargeable battery in the circuit.