What are the steps involved in installing connecting rod bearings?
What will be an ideal response?
1. Install the new bearing inserts in the rod and cap and lubricate them.
2. Bearing spread keeps the bearings in the rod while the pistons are being installed. A good bearing that is going to be reused might have lost its spread. According to Federal-Mogul Corporation, bearings can be respread by placing the bearing on a hardwood surface with the parting face down and gently tapping the back with a soft-faced mallet.
3. Check the parting surface of the rod cap to see that it does not have any burrs or foreign material that might prevent proper mating when it is torqued to the connecting rod.
4. Be certain that the bearing locating lugs are aligned in the cap.
You might also like to view...
All the following were true of the American economy under Cotton Kingdom EXCEPT
A. cotton accounted for half the value of all American exports after 1840. B. the South produced more than half the entire world's supply of cotton. C. 75 percent of the British supply of cotton came from the South. D. quick profits from cotton drew planters to its economic enterprise. E. the South reaped all the profits from the cotton trade.
What temperature scale uses 32° as the freezing point of water and 212° as the boiling point of water?
A) Kelvin B) Fahrenheit C) Rankine D) Celsius
Depending on the purpose of the exploded isometric assembly, the parts can be shown without identification, or they can be identified with balloons.
Answer the following statement true (T) or false (F)
An installer compares the areas of a circular duct and a rectangular duct. The 6-inch by 5-inch rectangular duct has an area of 30 sq in. The 5 1/2-inch diameter circular duct has an area of about 24 sq in. What is the ratio of the area of the circular duct to the area of the rectangular duct?
Fill in the blank(s) with the appropriate word(s).