This geometric tolerance requires that the actual feature be between two parallel planes or lines that are parallel to a datum.

a. profile
b. parallelism
c. perpendicularity
d. angularity


b. parallelism

Trades & Technology

You might also like to view...

Cellulose is:

A) The digestible part of the lignin. B) Part of the cell wall that can only be broken down by protozoa and bacteria. C) Part of the protein with the highest nutritive value. D) Digestible part of the cell contents. E) Undigestible part of the cell wall.

Trades & Technology

Most mechanical engine problems are caused by which of these?

A) Fuel Loss B) High RPM C) Overcooling D) Overheating

Trades & Technology

Which of the following is NOT a characteristic of conventional brake fluid?

A) Absorbs moisture from the air B) Lasts the life of the vehicle unless there is a leak C) Removes paint if spilled on vehicle surfaces D) Is clear or amber in color

Trades & Technology

A(n) ________ has a number of input lines, only one of which is activated at a given time, and produces an N-bit output code, depending on which input is activated

Fill in the blank(s) with correct word

Trades & Technology