Drilling in too far with a center drill:
A) Makes a sharp outer edge, which is a poor bearing surface
B) Makes the taper too large
C) Causes the chips to jam and the drill to heat up
D) Damages the center drill on the tapered section
A
You might also like to view...
?Why should air-conditioning linesnotbe disconnected?
What will be an ideal response?
Pausing for ____________________ from the client is one way that the presenter confirms the client's understanding of the proposal
Fill in the blank(s) with correct word
In a microprocessor system, what does the term "data bus" mean?
A) any connection between two ICs B) any parallel connection between registers that consists of eight or more lines C) any two-way data path D) a parallel set of conductors that is shared by several devices
Any time an air conditioning system is opened it must have the __________ replaced before evacuating the system.
A. Orifice tube B. Thermostatic expansion valve C. Receiver drier D. Compressor oil