All of the following statements about brake drum measuring and condition are true EXCEPT:
A. if the highest and lowest measurements taken at any straight-line position across the drum vary by 0.006 inch or more, machine the drum to correct the problem.
B. the diameter measured at the deepest groove must be 0.030 inch (0.75 mm) or more under the discard dimension.
C. drums that are smooth and true but exceed the new diameter by 0.090 inch or more should be reused without turning.
D. even slightly rough drum surfaces should be turned to ensure a true drum surface.
Answer: C
You might also like to view...
The detent mechanism inside a transmission is used to ________.
A) Prevent more than one shift fork from moving at one time B) Locate the synchronizer sleeves in the correct position C) Hold a gear into mesh D) All of these
Current research shows equivalent yields from conventional and conservation tillage if known
technology is applied to each tillage system and the systems are matched to crops and soil types.
Indicate whether the statement is true or false.Which Digital Multimeter (DMM) test mode would be used to bench-test transistors?
A. Volts DC B. Volts AC C. Ohms D. Milliamps
The answer is in this format: 5:9. Find the ratio of 200 turns of the primary coil to 800 turns of the secondary coil.
Fill in the blank(s) with the appropriate word(s).