While painting a vehicle, the technician notices that striping is occurring. What corrective measures must be taken to cure this condition?

What will be an ideal response?


How to repair:
? Allow correct flash time between coats
? If a coat is too wet, the technician should allow for the finish to flash before applying a second coat. Corrections in the spray gun adjustment and set-up can be made before the next coat.
? Cross-checking: Cross-checking means the technician will spray the panel in the opposite direction of the striped one. The technician should allow for proper flash time, after corrections to gun set-up have been made and a test pattern confirms that the spray pattern and adjustment is correct.
? Sand and refinish.
? If striping is severe, the finish will need to be reapplied.

Trades & Technology

You might also like to view...

Technician A says when installing an outer tie-rod end, the slot in the tie-rod sleeve must be directly above the opening in the sleeve clamp. Technician B says excessive front wheel toe change and wear on the front tire treads may be caused by a loose tie-rod end. Who is correct?

A. A only B. B only C. Both A and B D. Neither A nor B

Trades & Technology

Figure 26-9 What does the accompanying diagram show?

What will be an ideal response?

Trades & Technology

High-pressure valve seats that leak result in a(n) ____________________ or rising pressure on the working side of the regulator.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

The SEWA (Southwestern Electricity and Water Authority) authorized construction projects totaling $1.07 million to improve desalinization plant efficiency and salinity-reduction technology for reject chemicals. Three bids from potential vendors were received in the amounts of $1.06, $1.053, and $1.045 million. Assume the savings will be realized immediately for each bid, were it accepted. Use an expected life of 10 years and i = 6% per year to do the following for the savings anticipated from the lower-than authorized bids: (a) Determine the equivalent present worth of the savings. (b) Determine the equivalent annual worth of the savings. (c) Develop a column chart for the equivalent annual worth for the savings for each bid.

What will be an ideal response?

Trades & Technology