__________ and wheel cylinders are the outputs of the hydraulic system.

Fill in the blank(s) with the appropriate word(s).


Calipers

Trades & Technology

You might also like to view...

Which type of automotive bearing can withstand radial and thrust loads, yet must be adjusted for proper clearance?

A) Needle roller bearing B) Ball bearings C) Roller bearing D) Tapered roller bearing

Trades & Technology

Laminated veneer lumber (LVL) is

A) produced by gluing together wood veneers that are approximately 1/8 in. thick. B) glued with all veneers running in the same direction. C) generally used as floor joists and beams. D) stronger along the grain and weaker across the grain. E) all of the above.

Trades & Technology

The purpose of contactor 2M shown in Figure 3 is to _____.



a. short motor leads T4, T5, and T6 during starting to connect motor windings in a wye
configuration
b. energize motor leads T1, T2, and T3 for both wye and delta connections
c. energize motor leads T4, T5, and T6 during running to connect the motor windings in a
delta configuration
d. connect resistors in series with the motor windings during the transition from start to run

Trades & Technology

A mechanic works 3 1/4 hours on one car, 1 2/3 hours on another car, and 4 3/4 hours on a third car. What is the total number of hours worked?

A. 8 1/3 B. 9 2/3 C. 10 2/3 D. 11 1/3

Trades & Technology