You are making a 14" stub-up in 1" RMC and the bender deduct is listed as 10". Where do you make your first mark?
a. 1" from the end of the conduit
b. 4" from the end of the conduit
c. 5" from the end of the conduit
d. 6" from the end of the conduit
b. 4" from the end of the conduit
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Accidents in the home are often more severe than accidents at the workplace. 2. Safety is simply the absence of accidents. 3. Respirators are more substantial devices than masks. 4. It is acceptable to substitute one tool for another if you are familiar with all of the tools available. 5. Virtually all service shops use compressed air to assist with the day-to-day activities within the shop environment.
Answer the following statements true (T) or false (F)
1) Notifying 911 of an accidental discharge of a toxic substance is a standard hazard recognition procedure. 2) The two broad functions of the National Institute for Occupational Safety and Health (NIOSH) are research and education. 3) A toxic substance is one that has a negative effect on a person or animal. 4) The OSHA Standard for nanoscale toxic materials is 29 CFR.1910.623. 5) A major purpose of the GHS is to reduce the need for testing of materials and chemicals.
Technician A says that backspacing is the same as offset. Technician B says that backspacing is the distance between the back rim edge and the wheel center section. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
How is the length of a pop rivet determined?
A) By the radius of the tip of the pop rivet B) By the distance from the tip to the head of the pop rivet C) By the circumference of the head of the pop rivet D) By the width of the tip of the pop rivet