Which of the following is a disadvantage of a totem-pole output?
A) When switching LOW to HIGH, Q3 is changing from saturation to cutoff. This transition takes longer than Q4's transition so for a short period a surge current is drawn from Vcc.
B) When switching from HIGH to LOW, Q4 is changing from saturation to cutoff. This transition takes longer than Q3's transition so for a short period a surge of current is drawn from Vcc.
C) When switching from LOW to HIGH, Q4 is changing from saturation to cutoff. This transition takes longer than Q3's transition so for a short period a surge of current is drawn from Vcc.
D) Both A and C
C
You might also like to view...
The main shaft is also called the ________.
A) Counter shaft B) Intermediate shaft C) Clutch shaft D) Either A or B
The lintel is usually ____.
A. brick B. natural stone C. angle iron D. aluminum
Which of the following is a resource reservation enhancement to the 802.11 MAC layer that enables prioritization of traffic?
A. SMPS B. QoS C. RIFS D. PSMP
Carry the answer to three decimal places. A set of 2-inch-wide by -inch-thick carbon brushes fits the brush holders too tightly. It is necessary to take
inch off the width and 0.015 inch off the thickness by sanding. Give in decimal form the thickness dimension of the carbon brushes after sanding.
Fill in the blank(s) with the appropriate word(s).