The frequency is known as ohms but many times, it is referred to as cycles.
Answer the following statement true (T) or false (F)
False
Rationale: The frequency is known as hertz (Hz), but many times it is referred to as cycles.
You might also like to view...
Answer the following statement(s) true (T) or false (F)
1. Once the soldering iron is placed on the area to be soldered, it is not moved until it is removed completely from the finished joint. 2. Leads of DIPs should be soldered consecutively. 3. In cases where there are 10, 12, 14, or more layers in a Through Hole board, the entire board may need to be preheated to around 212°F (100°C) before trying to solder or desolder a component lead. 4. For a connection that has just been made but needs to be redone properly, the use of flux is not usually necessary. 5. When a pad or lead is heated up, the glue holding the copper onto the board loses 80% of its strength.
The dangerous by-product of poor combustion of gas is _________________________.
Fill in the blank(s) with the appropriate word(s).
A problem with the basic op-amp instrumentation amplifier is
A) low CMRR noise reduction B) high common-mode gain requires precisely matched resistors C) large power consumption D) comparatively low input impedance
Which states currently license construction management as a separate profession?
What will be an ideal response?