A dimension obtained by adding or subtracting other dimensions found on a welding drawing is known as a

_____.

a. baseline dimension
b. standard dimension
c. reference dimension
d. conventional dimension


c

Trades & Technology

You might also like to view...

The spacings of columns for most commercial buildings fall into the _______________ to _______________ range, with _______________ being about the maximum unless the designer intends to use high-strength steel or joist girders.

Fill in the blank(s) with the appropriate word(s).

Trades & Technology

How many pounds of salt should be allocated per cow per year?

A) 36 lbs B) 6 lbs C) 24 lbs D) 48 lbs E) 12 lbs

Trades & Technology

The fuel pump is located where in TBI and port electronic fuel injection systems?

A) Front of the engine, driven by an accessory drive belt B) Mounted on the engine C) Rear of the engine, driven by the engine crankshaft or camshaft D) Inside the fuel tank

Trades & Technology

Which of the following may be a sign of tire failure?

a. loud hissing noise. b. Gentle thumping . c. wheels fishtailing.

Trades & Technology