When setting the ignition timing on a coil-on-plug ignition system, the technician must first ________
A) Loosen the distributor lock plate
B) Disconnect the SPOUT connector (Ford vehicles)
C) Loosen the crankshaft position sensor bolts
D) None of these; the timing cannot be adjusted
D
You might also like to view...
Which air control door selects where the air is directed?
A) Mix door B) Blend door C) Mode door D) Inlet door
A load-bearing wall structure works best when the floor plan of the building has ________.
A) walls at an upper floor that align with the walls at a lower floor. B) walls that are distributed almost uniformly in both principal directions. C) walls that are continuous up from the foundations. D) all of the above.
A PN junction diode is most commonly used as a ____.
a. fast-acting switch b. light source c. voltage regulator d. rectifier
Determine the resultant vector in standard position for the following vectors and express the magnitude to 3 significant digits and the angle to the nearest tenth degree. = 151.5 ft/s at 19.6°,
= 207 ft/s at 243.0°
Fill in the blank(s) with the appropriate word(s).