?What can be done if a number of parts are made within tolerance so that the parts' overall finished size will be within its tolerance?
A. ?Make the part a little smaller so that the parts can be used.
B. ?Adjust the weld joint fitup within its tolerance to compensate for the parts' tolerance.
C. ?Change the design to allow the parts to be used so that the cost of new parts can be avoided.
D. ?Discard the parts and start the project over with new more accurately cut parts.
Answer: B
You might also like to view...
This is a machine element that is used to provide a positive connection for transmitting torque between a shaft and a hub.
a. taper pin b. retaining ring c. key d. dowel pin
What is the purpose of a sand pit in a degu enclosure?
What will be an ideal response?
Too little stress can cause a person to
a. feel invigorated. b. be healthy and pleased with life. c. develop healthy coping techniques. d. become bored. e. become anxious about time pressures.
Answer the following statement(s) true (T) or false (F)
1. A cow with excessive fat produces the ideal amount of milk. 2. A heifer or bull with a large, extended brisket is probably at ideal weight. 3. Breeding animals require no muscling. 4. Narrow animals lack adequate muscling. 5. Tightly wound bulls have problems mounting during mating.