When leveling brick, the following procedure should be followed:
A. High brick should be removed and relaid in fresh mortar.
B. Use a hammer rather than a trowel to tap down any brick that is high in relation to level.
C. Brick that is low in relation to the level must be picked up and relaid in fresh mortar.
D. Use a trowel to lift brick that is low in relation to level and add mortar to raise the brick to level.
Answer: C
You might also like to view...
Which improper activities will not cause collapse of a tank because of a vacuum?
A) Loss of nitrogen flow B) Misalignment of blanket systems C) Emptying a tank D) Misalignment of pump systems
On ____, if the tube is not vertical, the reading is not accurate.
A. gas flowmeters B. air flowmeters C. ball-type flowmeters D. aluminum flowmeters
Symbol F in Figure 2 represents a _____.
a. float switch
b. temperature switch
c. pressure switch
d. foot switch
An acronym sometimes used to describe the process of preparing for the crea¬tion of a constraint-based model is TAP, representing the steps Think, Ana¬lyze, and Plan. Consider what it means to think, analyze, and plan a constraint-based model. Why are these steps especially important prior to beginning the constraint-based model?
What will be an ideal response?