The ____ is sent to the final control element.
A. measured variable
B. feedback signal
C. error signal
D. control signal
Answer: D
You might also like to view...
Which of the following best describes continuity monitoring?
a. Initiates an alarm when the current in the heat-tracing circuit is too low or too high b. Measures the temperature of the pipe with a digital controller connected to an RTD c. Monitors the current leakage from the system heating cable, power wiring, and components to ground d. Verifies that voltage is present at the end termination of a heat-tracing cable run
Sam is scheduled to work 9.3 hours per day. How many hours will he work if he works 5.4 days per week?
What will be an ideal response?
Find the flow rating, in gallons per minute, of a pump that displaces 0.850 in^3 per revolution, and turns at a rate of 2200 RPM. Round to the nearest tenth
What will be an ideal response?
The measure of one angle is 7° 55'. What is the total number of degrees and minutes in 4 of these angles?
What will be an ideal response?