Which of the following would be an appropriate location for use of a soil stabilizer?

a. steep hillside
b. flat area exposed to wind
c. channel with high volume
d. all of the above


b. flat area exposed to wind

Trades & Technology

You might also like to view...

The tool shown in the above figure is used to _____.



a. measure the inside diameter of tubing
b. cut copper tubing
c. make threads in tubing
d. measure thread pitch

Trades & Technology

The part MOST-Likely used to compare the reading inside the engine to an absolute pressure calibration in the computer is the:

A. MAP sensor B. BARO sensor C. TPS sensor D. Plenum

Trades & Technology

Static pressure readings are taken on a duct system by:

A) Subtracting the velocity pressure from the total pressure. B) Pointing the pressure-sensing tube into the airstream. C) Subtracting the total pressure from the velocity pressure. D) Pointing the pressure-sensing tube perpendicular to the air stream.

Trades & Technology

A window is 2 feet 10 inches across.  What is the largest width air conditioner in inches that will fit in the window?

Fill in the blank(s) with the appropriate word(s).

Trades & Technology