Technician A says that OEMs are use the term flash memory to describe any type of programmable onboard memory. Technician B says that true flash memory is faster to transfer than EEPROM because it batched in blocks of bytes. Who is correct?
A. Technician A only
B. Technician B only
C. Both A and B
D. Neither A nor B
Answer: C
You might also like to view...
Which wire on a typical TP sensor should back-probed to check the voltage signal to the PCM?
A) Signal wire B) Ground wire C) 5-volt reference (Vref) D) Meter should be connected between 5-volt reference and ground
Which of the following pulls requires the length of the box to be no less than eight times the trade diameter of
the largest raceway? A) Straight pull B) Angle pull C) U pull D) Circle pull
Matched processors for two orthogonal signals for multiple access.
The following worksheet specifies a pair of 10-sample CDMA orthogonal data signals: sA sub "1" in B5:B14 and sB sub "1" in C5:C14. Random transmitted bits DA sub "t" and DB sub "t" are computed in B1 and D1. The transmitted signal sAT sub "i" (in D5:D14) = sA "sub "i" if DAt=1 and =-sA sub "i" if DAt=0. The transmitted signal sBTi (in E5:E14) = sBi if DBt=1 and =-sBi if DBt=0. The Gaussian noise sequence Ni SD ? sub "N" is specified in F1. The detected signal X sub "i" is computed in G5:G14. The matched processor component sAiX sub "i" is computed in H5:H14 and VA is computed in H16. The detected bit DAr is computed in B2 from VA. The matched processor component sB sub "i" X sub "i" is computed in I5:I14 and VB is computed in I16. The detected bit DB sub "r" is computed in D2 from VB.
a. What is the formula in B1?
b. What is the formula in D1?
c. What is the formula in D2?
d. What is the formula in F2?
e. What is the formula in D10?
f. What is the formula in E10?
g. What is the formula in F10?
h. What is the formula in G10?
i. What is the formula in H10?
j. What is the formula in H16?
k. What is the formula in B2?
l. What is the formula in I10?
m. What is the formula in I16?
n. What is the formula in D2?
o. What is the formula in L1?
p. What is the formula in L4?
q. Compose ResetMA.
r. Compose XmitMA.
s. Compose AutoMA.
PROBLEM 2.C6 A solid truncated cone is subjected to an axial force P as shown. The exact elongation is By replacing the cone by n circular cylinders of equal thickness, write a computer program that can be used to calculate the elongation of the truncated cone. What is the percentage error in the answer obtained from the program using (a) (b) (c)
