In a typical measurement system, with a single cut-off frequency, what can you say about the attenuation in the output amplitudes for frequencies just above (but close to) the cut-off frequency?
A. there is partial attentuation
B. there is no attenuation
C. there is full attentuation
Answer: A
Trades & Technology
You might also like to view...
What is an advantage of extrusion coating? ?
A. ?labor costs are low B. ?no solvents are needed C. ?equipment is not costly D. ?the process is simple
Trades & Technology
What views are shown?
Review drawing number 523879C0A and then answer the question.
Trades & Technology
What is the opening in the wall that allows water to pass through called?
a. weephole b. pass through c. french drain d. gabion
Trades & Technology
Technician A says electrical switches are used to open and close electrical circuits. Technician B says electrical switches are used to control the operation of other devices. Who is correct?
A. A only B. B only C. Both A and B D. Neither A nor B
Trades & Technology