Where is the rotary control valve located on a power rack and pinion steering gear?

A) Behind the mounting brackets
B) Between the steering gear input shaft and the pinion gear
C) Under the dampening adjuster
D) In the rack tube, just behind the rack seal retainers


B

Trades & Technology

You might also like to view...

A developer wants to provide access to a new building from a driveway placed 1000 ft upstream of a busy intersection. He is concerned that queues developing during the red phase of the signal at the intersection will block access. If the speed on the approach averages 35 mi/hr, the density is 50 veh/mi, and the red phase is 20 sec, determine if the driveway will be affected. Assume that the traffic flow has a jam density of 110 veh/mi and can be described by the Greenshields model.

What will be an ideal response?

Trades & Technology

Which of the following is most correct as regards cooperatives?

a. Farmer cooperatives are declining in terms of numbers. b. Cooperative may involve inputs, outputs, or support functions. c. The cooperative form of organization has been frequently used in agribusiness. d. All of the above are correct. e. None of the above are correct.

Trades & Technology

The resistance of an AC magnetic device will have ________ resistance than Ohm's law predicts

A) a much lower B) a much higher C) the same

Trades & Technology

This is a screen placed at the top of the flue to prevent combustibles from leaving the flue:

A. chimney liner B. flue C. chimney anchors D. chimney cap E. chimney hood

Trades & Technology