Technician A says that the steering lever is attached to the steering knuckle on the driver's side of the equipment atone end and connects to the tie rod. Technician B says that the steering knuckle is the pivot used on each front axle wheel. Who is correct?
A. Technician A
B. Technician B
C. Both
D. Neither
Answer: B
You might also like to view...
A hot AC generator loses 75% of its rated output.
Answer the following statement true (T) or false (F)
The principles of design help people develop good designs that are economical to install even though they may be difficult to maintain
Indicate whether the statement is true or false
Heat can move or travel by ________
A) Convection B) Radiation C) Conduction D) All of these
When torquing the rim lug (clamp) nuts on a truck cast spoke wheel, which of the following should be true about the method, torque sequence, and position you torque each nut?
A. wheel down, circular torque sequence, torque each nut at 12 o'clock B. wheel down, criss-cross torque sequence, torque each nut at 6 o'clock C. wheel up, criss-cross torque sequence, torque each nut at 12 o'clock D. wheel up, circular torque sequence, torque each nut at 6 o'clock