To determine if the contacts inside a sequencer are faulty, the technician should energize the relay so the contacts are made and use an ohmmeter set to the RX1 scale. Which of these readings indicate that the sequencer must be replaced?

A) resistance between 0 and 0.1 ohm B) resistance less than .1 ohm
C) resistance greater than 0.1 ohm D) resistance of 0 ohm


C

Trades & Technology

You might also like to view...

The average age of engineering students when they graduate is a little over 23 years. Let’s assume that the working career of most engineers is exactly 40 years (retiring at 63). How much would an engineer need to save each month to have $3 million saved by the end of his or her working career? Assume i = 5.0 percent compounded monthly.

What will be an ideal response?

Trades & Technology

Repeat Problem 8-16 using saturation flow rates that are 10% higher. What effect does this have on cycle length?

What will be an ideal response?

Trades & Technology

Use Laplace transforms to solve for x(t) in

What will be an ideal response?

Trades & Technology

A Wheatstone bridge such as that shown in Figure P3.59 is used in numerous practical applications, such as determining the value of an unknown resistor RX .

Trades & Technology