What should be put in place for safety reasons when using a shop press?
a. a screen
b. a tarp
c. a heavy sheet of steel d. a clear piece of plastic
A
You might also like to view...
The ________ shows the total standard time required to produce one end product in each work center required for its manufacture
A) bill of material B) work center master C) item master D) routing
Technician A says that J1939 node activity can be identified using a DMM set on V-DC min-max mode. Technician B says that the V-DC min-max readings taken while verifying J1939 bus activity should run between a low of 1 volt and a high of 5 volts. Who is correct?
A. Technician A only B. Technician B only C. Both A and B D. Neither A nor B
Which of the following components is where the source voltage is present?
A. Open B. Working C. Closed D. Defective
In a typical four-cylinder engine, which cylinders are paired together by their position on the crankshaft?
A. 1 and 2, 3 and 4 B. 1 and 3. 2 and 4 C. 1 and 4, 2 and 3 D. None are paired