When first setting up a new communicating control system:
A) The technician enters the control code on each individual component access screen.
B) The system automatically scans the network for connected devices.
C) The technician must enter the communicating address and function of each component in the system.
D) The technician must connect a laptop to each device in the network.
B
You might also like to view...
All of these were indictments by Thomas Jefferson of George III EXCEPT:
A. establishing a military dictatorship B. cutting off trade C. burning towns D. ending all private property E. hiring mercenaries
The point where one weld bead stops and another starts is referred to as a(n) _____
a. restart b. termination c. arc strike d. weld defect
What usually causes downward modulation?
A. Improper phase relationship B. Interfering frequency components C. Stray coupling D. Insufficient excitation
If you pull a pendulum back and let it go, the time required for it to return to approximately the same place from which it was released is called
a. the period b. the frequency c. the natural frequency d. the amplitude